Special set-up of a GS-Series ductless fume cupboard designed to meet the specific needs of the user. Dedicated to the enclosing of devices that have a working height of more than 90cm which are liable to release toxic substances and tha, for maintenace purpose, should be occasionally been extracted from the hood. Ideal solution for instruments such as tissue processors typically used in anathomy/pathology labs. This special outfitting includes a out-standard dimension (external depth 1000mm, internal depth 840mm) and a base with height increased to 100cm equipped with front doors with key lock. The working chamber is closed at the bottom with an AISI304 stainless steel tray without front edge to allow the extraction and introduction of machinery. The lower front crosspiece of the fume cupboard is removable after unscrewing N. 2 M6 knobs to allow easy access.
Equipped with embedded filtration system, it allows the protection of personnel without the need of any complex ventilation systems for channeling the air outside of the building. Filters for powders or vapors or combinations of these can be installed to allow the hood to be suitable for any use.
If necessary, the fume cupboard can also be ducted on an existing system through an exhausting manifold installed on the external upper cover but mantaining at same time the embedded filtration system. In this condition the blower present on the fume cupbaord is able to work with a limited channel length to be evaluated at the time of request.
Upper frame made in Fe37 epoxy-polyester coated colour RAL7035
Aluminium extruded uprights epoxy-polyester coated colour RAL7015 made with highly aerodinamic efficiency
AISI304 stainless steel working area equipped with internal back-baffles especially designed
Counterweighted frontal sash made in safety glass 3+3 PVB
AISI304 stainless steel bottom tray
Full accessibility base-stand with key-locked doors (270° opening) made in rolled steel epoxy-polyester coated
CEI64.2 IP44 electrical system with magneto-thermic switch
Three-steps-speed electronically controlled blower triggered by sash movement
250mm diameter exhaust manifold
Who we are
The Gruppo Strola is involved for over 30 years in the design and implementation of solutions for the containment of vapors / toxic molecules released during laboratory manipulations. Thank to our experience with projects accomplished in Italy and all over the world and a constant research for advanced technical solutions, we are able to produce solutions against chemical hazards in the laboratory for maximum protection of operators.
Gruppo Strola s.a.s.
Via Carlo Pittara 52
10158 Torino, Italy
P.iva IT 05012570015